Filter
Top Products
Setting Up Studio Package Pro
15
5. Make settings as shown in the illustration.
fig.M03.eps
6. Click the “Patchbay/Router” tab.
7. As shown in the illustration, set the “R-Bus Out 1/2” source to
“Monitor Mixer.”
8. Click the “Hardware Settings” tab.
9. Check “Disable ... Monitor Mixer and Patchbay/Router”
fig.M05
or
fig.DisableAudioAppUse.eps
*The wording may differ according to the OS you are using.
10. Click [Save] to assign suitable name to the settings, and then
click [OK] to save them.
If for some reason the settings are changed, you can load the
settings that you saved here. Click [Load] in the RPC-1 control
panel to load the settings.
11. Click [Done] to close the RPC-1 control panel.
Set pan to left or right.
Set all of the “R-Bus In 1/2”--“R-Bus In 7/8” faders
to 0 dB (top).
Un-check both “Mute” settings.