Sony SRP-X500P Music Mixer User Manual


 
SRP-X500P RS-232C Interface Manual
INPUT LEVEL (16th-21st byte)
Shows the value indicated by the yellow triangular marker at the side of the input fader in the OVER
VIEW screen of the SRP-X500P Manager. This value is calculated using the input volume parameter,
input fader parameter, master volume level parameter, and remote fader 1-6 parameters and this
indicates the total input level value.
The INPUT LEVEL parameter consists of the 6 bytes of data in the order shown in the following table.
Byte Parameter
1st MIC 1/WL 1 INPUT LEVEL
2nd MIC 2/WL 2 INPUT LEVEL
3rd MIC 3 INPUT LEVEL
4th MIC 4 INPUT LEVEL
5th LINE INPUT LEVEL
6th AV/RGB INPUT LEVEL
The correspondence of the parameter with the level setting is the same as that of the FADER
parameter of the INPUT FADER command (page 7).
OUTPUT LEVEL (22nd-29th byte)
Shows the value indicated by the yellow triangular marker at the side of the output fader in the OVER
VIEW screen of the SRP-X500P Manager. This value is calculated using the output fader parameter,
master volume level parameter, and remote fader 1-6 parameter. This value is an indication of the total
input level value.
The OUTPUT LEVEL parameter consists of 8 bytes of data in the order shown in the following table.
Byte Parameter
1st SPEAKER OUTPUT 1 LEVEL
2nd SPEAKER OUTPUT 2 LEVEL
3rd SPEAKER OUTPUT 3 LEVEL
4th SPEAKER OUTPUT 4 LEVEL
5th LINE OUTPUT 1 LEVEL
6th LINE OUTPUT 2 LEVEL
7th LINE OUTPUT 3 LEVEL
8th LINE OUTPUT 4 LEVEL
The correspondence of the parameter with the level setting is the same as that of the FADER
parameter of the INPUT FADER command (page 7).
INPUT MUTING (30th byte)
Shows the muting status of the input channels in the form of 8 bits data.
The bit is 0 for a channel which is not turned off (
Muting off”) and 1 for a channel which is turned
off (
Muting on”).
MSB LSB
bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0
0 1 AV/RGB LINE MIC 4 MIC 3 MIC 2 MIC 1
/WL 2 /WL 1
Page 27/43