Sony SRP-X500P Music Mixer User Manual


 
SRP-X500P RS-232C Interface Manual
SETUP STATUS
Shows the progress of the FEED BACK REDUCER setting.
The parameter and the progress are as shown in the following table.
Progress
Stopped (finished) 0x30 (‘0’)
1 0x31 (‘1’)
2 0x32 (‘2’)
3 0x33 (‘3’)
4 0x34 (‘4’)
5 0x35 (‘5’)
6 0x36 (‘6’)
7 0x37 (‘7’)
8 0x38 (‘8’)
9 0x39 (‘9’)
10 0x3A (‘:’)
11 0x3B (‘;’)
12 0x3C (‘<‘)
13 0x3D (‘=‘)
14 0x3E (‘>‘)
15 0x3F (‘?’)
AV/RGB INPUT SELECT (56th byte)
Shows the selection of the channel input from among the AV/RGB INPUT connectors.
The parameter and the channel are shown in the following table.
Channel
OFF (All the AV RGB SELECT buttons are turned off.) 0x30 (‘0’)
A (The AV RGB SELECT A button lights up.) 0x31 (‘1’)
B (The AV RGB SELECT B button lights up.) 0x32 (‘2’)
C (The AV RGB SELECT C button lights up.) 0x33 (‘3’)
D (The AV RGB SELECT D button lights up.) 0x34 (‘4’)
E (The AV RGB SELECT E button lights up.) 0x35 (‘5’)
SPEAKER OUTPUT LEVEL (57th, 58th byte)
Shows the level of the SPEAKER OUT controls on the front panel of the SRP-X500P.
The SPEAKER OUTPUT LEVEL parameter consists of the 2 bytes of data in the order shown in the
following table.
Byte Parameter
1st SPEAKER OUTPUT CH1/2 LEVEL
2nd SPEAKER OUTPUT CH3/4 LEVEL
The correspondence of the parameter with the speaker output level is the same as that of the LEVEL
parameter of the REMOTE 1-6 LEVEL command (page 10).
Page 32/43