Filter
Top Products
10. EQ TO MONITOR
As mentioned above, the HF/LF EQ section is usually
in the Channel path. Pressing EQ TO MNTR switches
these controls to the Monitor path, while leaving the
HIGH MID and LOW MID controls in the Channel path.
11. HIGH AND LOW MID SWEEP EQ
The HMID and LMID EQ controls are usually in the
Channel path, and by careful choice of frequency limits
provide a comprehensive range of equalisation. The
two pairs of knobs are arranged as a CUT/BOOST con-
trol (lower knob) of +/-15dB and a SWEEP (frequency)
control which determines at which frequency the
boost/cut action will be centred. The HMID control
covers a range from 500Hz to 16kHz, and the LMID
control covers a range from 50Hz to 1.6kHz.
Note that when the CHANMNTR INPUT REV switch (7)
is pressed this section, along with the rest of the Chan-
nel path controls, are fed by the Tape Return signal.
12. AUXILIARY SENDS
These controls route the input channel signal to any
one or more Auxiliary busses. These are separate
20.0
15.0
10.0
5.0
0.0
-5.0
-10.0
-15.0
-20.0
20
1k 10k 20k
100
dB
Frequency/Hz
LOW MID Section
Frequency Response Curves of the Equaliser
20.0
15.0
10.0
5.0
0.0
-5.0
-10.0
-15.0
-20.0
20
1k 10k 20k
100
dB
Frequency/Hz
HI MID Section
Page 13