Filter
Top Products
21. AUXILIARIES TO CHANNEL
FB2 and AUX 3 & 4 are normally in the Monitor path.
Pressing CHAN routes AUX 3 & 4 to the Channel path,
while FB2 remains unaltered.
22. MONITOR PAN
The Monitor PAN control determines the position of the
signal within the stereo image. Rotation fully anticlock-
wise feeds the signal solely to the Left mix buss, while
rotation clockwise sweeps the image to the Right.
23. MONITOR FADER
This rotary control determines the overall level of the
Monitor signal path. Unity gain point is at approximately
7.5 on the scale.
24. MONITOR PFL/PEAK LED
When the PFL switch is pressed, the Pre-Fade signal is
fed to the Control Room and headphones outputs,
where it replaces the selected source. The PFL/AFL
LED on the master section illuminates to warn that the
monitor and the meters are now responding to the
PFL/AFL selection and the PFL LED on the input chan-
nel lights to identify the active channel.
When the PFL switch is released the LED on the chan-
nel serves as a PEAK indicator, to warn when an
excessively high signal level is present in the Monitor
path. The signal is sampled at two points in the Moni-
tor path, PRE FADE (PRE HF/LF EQ if in the Monitor
path). The Peak LED will illuminate approximately 4dB
before clipping.
25. MONITOR ON
The Monitor path is disabled unless the ON switch is
pressed - except FB2 which is always active. The
switch is post-fade to minimise system noise when
OFF.
GROUP SECTION
Page 16