Filter
Top Products
16
Switching Between PAL and NTSC Video Modes
The DVX-668K is defaulted to NTSC. Use the N/P button on the remote control to switch between PAL and
NTSC.
1. If there is a disc in the DVX-668K, make sure it is stopped.
2. Press the N/P button on the remote control.
NTSC: North America
PAL: Europe and A
sia
Changing the Video Output Mode
The DVX-668K has different video output channels: RGB, YUV, P-SCAN, S-Video. The DVX-668K must be set
to the correct video output mode when using these output channels.
To cycle through the different video output modes:
1. If there is a disc in the DVX-668K, make sure it is stopped.
2. Press the V-MODE button on the remote control.
Looping a Section of Disc using the A--B Button (CD, VCD, DVD and USB)
1. Press the A--B button on the remote control to set the starting point of the loop.
2. Press the A--B button again to set the ending point of the loop and to begin the loop.
3. Press the A--B button a third time to cancel the loop and resume normal playback.
Using the Digital Equalizer (EQ)
The DVX-668K has five preset equalizer settings.
1. Press the SETUP button on the remote control to open the SETUP menu.
2. Select > Audio Setup Page > Equalizer > EQ type.
3. To change the EQ settings, choose one of the following modes:
None, Rock, Pop, Live, Dance, Techno,
Classic, or Soft.
4. Press the ENTER button to confirm your setting.
Playing One Frame at a Time with the Step Function
The Step function allows you to view one frame at a time on DVDs and VCDs.
NOTE: The Step function does not work on CD+Gs.
1. Press the STEP button to enter Step mode and pause the current frame.
2. Press it again to jump to the next frame.
3. Press PLAY to resume normal playback.
General Operations