Filter
Top Products
39
AC INLET
MIDI
AUX IN
HOST SELECT TO HOST
IN OUT
RL
/
L+R
THRU
PC-2 PC-1
Mac
MIDI
AUX OUT
RL
/
L+R
(CLP-811)
MIDI
AUX IN
HOST SELECT TO HOST
IN OUT
RL
/
L+R
THRU
PC-2 PC-1
Mac
MIDI
AUX OUT
RL
/
L+R
4
5
6
78
CLP-811/611 The Clavinova’s Device Connectors
4 AUX IN jacks (R and L/L+R)
5 AUX OUT jacks (R and L/L+R)
• AUX IN R and L/L+R
These standard phone jacks accept
connection from a synthesizer, tone-
generator module (such as the
YAMAHA DOU-10 Disk Orchestra
Unit), or other such playback
device. Sound transmitted from the
external device is produced by the
Clavinova’s internal speakers. Make
the connection (using standard
audio cord) as illustrated at right.
NOTE
A line-level mono source can be connected to the L/L+R jack.
• AUX OUT R and L/L+R
You use these standard phone
jacks to feed Clavinova output
to an external stereo recorder,
amplifier, or other such device.
This makes it possible, for
example, to record the sound to
a tape recorder or cassette, or
to produce it through external
speakers. Make the connection
(using standard audio cord) as
shown above.
When connecting to a stereo unit, set the [MASTER VOLUME] slider to center position and
adjust the volume at the recording side.
NOTE
If a line is inserted into the L/L+R jack only, the Clavinova mixes left- and right-
channel signals and outputs them over this line. This ensures that you don’t lose any
of the Clavinova’s sound.
6 MIDI IN, OUT, and THRU connectors
These are used to connect to external MIDI devices. Note that you must set the HOST SELECT
switch (described below) to MIDI in order to enable use of these connectors.
For basic information about MIDI connections and operation, refer to page 48.
7 HOST SELECT switch, and 8 TO HOST connector
TO HOST connector....
Allows direct connection to a personal computer.
HOST SELECT switch...
Sets the connection type. If connecting directly to a personal computer, you use this switch to
select the computer type. If connecting via MIDI, set this switch to the MIDI position. Refer to
“Connecting to a Personal Computer” (page 40) for detail.
Never feed AUX OUT output
back into the AUX IN jacks.
When using AUX OUT to
connect to an external device, do
not connect that device back to
the AUX IN at the Clavinova side.
Since the AUX OUT signal
always includes all sound
received at the AUX IN jacks,
interconnection will create a
feedback loop that will distort the
sound and may cause damage to
your equipment.
Audio cord (and adaptors, if
required) should be non-
resistance type.
The Clavinova’s [MASTER
VOLUME] slider and REVERB
setting do not affect the sound
received at the AUX IN jacks.
AUX IN
Audio cord
OUTPUT
Clavinova
Standard
phone plugs
MIDI
AUX IN
HOST SELECT TO HOST
IN OUT
RL
/
L+R
THRU
PC-2 PC-1
Mac
MIDI
AUX OUT
RL
/
L+R
DOU-10 or
Synthesizer, tone-
generator
module,...
Clavinova
MIDI
AUX IN
HOST SELECT TO HOST
IN OUT
RL
/
L+R
THRU
PC-2 PC-1
Mac
MIDI
AUX OUT
RL
/
L+R
Standard
phone plugs
AUX OUT
Pin-phone
adaptors
Pin plugs
Audio cord
Pin plugs
Stereo
AUX IN
or