Filter
Top Products
Registration Memory
5
27
4 Registration Shift
The Registration Shift function allows you to change registrations, all the
settings you make on the panel, without taking your hands from the
keyboards. Each press of the Right Footswitch on the Expression pedal
selects the registrations in numerical order.
NOTE:
• Although the number of the Registration
Memory buttons of EL-200 is limited to
eight, from Registration Memory 1
through Registration Memory 8, you can
select the other eight Registration
Memory numbers, the Registration
Memory 9 through Registration Memory
16.
• After the last registration is reached, the
function “wraps around” to select the
first preset again.
Resetting the Electone to the Factory Preset (Power On Reset)
All current settings including Registration Memories can be deleted at once
by using the Power On Reset function.
1. Turn off the power.
2. While holding the PEDAL/2 button in the
Keyboard Percussion section,
turn the power back to on.
Be careful when using this operation,
since it erases all your existing data.
Always save your important data to a
floppy disk using M.D.R. (page 28) in
advance.
Restoring the Registrations Before Turning the Power off
Turning the Electone off erases all panel settings you have made. When the
Electone is turned on, Basic Registration 1 is automatically selected.
If you have made panel settings you wish to keep, save them to Registration
Memory before turning the Electone off.
You can, however, restore the panel settings that were made before the
Electone was last turned off.
1. Turn on the power.
2. In doing this, first be careful NOT to press any panel buttons (excepting
those in Basic Registration), then hold down the M (Memory) button in
the Registration Memory section and press D (Disable) button.
D.87654321
M.
/TO DISK
The Electone restores the registration settings before turned off.
POWER
KEYBOARD
PERCUSSION
LOWER
1
PEDAL
2