Filter
Top Products
124
Performance Mode
■ InsEF (Insertion Effect)
Shows the on/off status of the Insertion Effects. If
“on” is displayed, this means that the Part’s signal is
being sent to the Insertion Effect Unit.
Insertion Effect switches for each Part are set in the
EFF Part screen (Page 117).
Part Receive Switch
Each Part can be set to receive Control Change and
Program Change messages. The following four screens
are available.
RCV Sw1 (Receive Switch 1)
RCV Sw2 (Receive Switch 2)
RCV Sw3 (Receive Switch 3)
RCV Sw4 (Receive Switch 4)
RCV Sw1 (Receive Switch 1)
When set to “on,” each Voice in each Part will receive
Control Settings (PB, MW, RB,AT) and Control Change
messages. The Controller parameters will vary
according to the Part selected.
This screen is not available for the A/D Input Part.
Parts 1 to 16
Drum Voice Part
Plug-in 1/2 Part
Multi Plug-in Part
❏ Settings:
PB (Pitch Bend Wheel): off, on
MW (Modulation Wheel): off, on
RB (Ribbon Controller): off, on
AT (Aftertouch): off, on
RCV Sw2 (Receive Switch 2)
When set to “on,” each Voice in each Part will receive
messages from Knob [1]/[2], plus Breath Controller,
Foot Controller and Control Change messages.
This screen is only available for Parts 1 to 16 (including
Drum Voice Parts).
RCVíSw1) PB MW AT
PartP1 on off off
RCVíSw1) PB MW RB AT
Part01 on off on off
Parts 1 to 16
Drum Voice Part
❏ Settings:
Knob1 (Knob [1]): off, on
Knob2 (Knob [2]): off, on
BC (Breath Controller): off, on
FC (Foot Controller): off, on
RCV Sw3 (Receive Switch 3)
When set to “on,” each Voice in each Part will receive
volume, pan, sustain pedal, foot switch and Control
Change messages.
Parts 1 to 16
Plug-in 1/2 Part
Multi Plug-in Part
Drum Voice Part
A/D Input Part
❏ Settings:
Vol (Volume): off, on
Pan: off, on
Sus (Sustain): off, on
FS (Foot Switch): off, on
RCV Sw4 (Receive Switch 4)
When set to “on,” each Voice in each Part will receive
Program Change and Control Change messages when
you change Performance Bank/Program.
❏ Settings:
BankSel (Bank Select): off, on
PgmChng (Program Change): off, on
CtrChng (Control Change): off, on
RCVíSw4) BankSel PgmChng CtrChng
Part01 off on off
RCVíSw3) Vol Pan FS
PartAD on off off
RCVíSw3) Vol Pan Sus
Part01 on off on
RCVíSw3) Vol Pan Sus FS
Part01 on off on off
RCVíSw2) Knob1 Knob2 BC FC
Part01 on off on off