Filter
Top Products
153
Appendix
Sound is very quiet.
• Has the MIDI volume or MIDI expression been set too low?
• Has the filter cutoff frequency been set too high/low? (Pages 72, 96, 115, 120)
The pitch is wrong.
• Have the NoteShift and Tune parameters in the MSTR TG screen of Utility Mode been set correctly? (Page 134)
• Have the Oct and Trnspose parameters in the MSTR Kbd screen of Utility Mode been set appropriately? (Page 134)
• Have the pitch related parameters in PITCH menu (Voice Edit) been set appropriately? (Page 80)
• Has the Micro Tuning parameter in Voice Edit Mode been set to an unconventional scale? (Page 71)
• Has the Pitch Modulation Depth in the LFO screen (Voice Edit Mode) been set too high? (Page 91)
• For Performances, has the Note Shift parameter in the LYR (Layer) screen been set to a value other than 0? (Page 123)
• For Performances, has the Detune parameter for each Part been set to a value other than 0? (Page 123)
Sound is choppy and intermittent.
• Has the maximum polyphony been exceeded? (Page 33)
Only one note sounds at a time.
• Has the Mode parameter in the GEN Other screen of Voice Edit Common been set to “mono”? (Page 71)
• In Performance Mode, has the Mode parameter in the LYR Mode screen been set to “mono” for each Part? (Page 122)
No effects are applied.
• Has the [EF BYPASS] key been set to OFF? (Page 56)
• Has the Insertion Effect Element Switch parameter in the EFF screen of Voice Edit been set to ON? Also in this Mode, has
the effect type been set to something other than “thru” or “off”? (Page 78)
• For Performances, have the Insertion Effect Parts been specified? (Page 117)
• For Reverb and Chorus, have the effect types in the Common Edit screens been set to ON? (Pages 79, 118)
• If an Effect Plug-in Board has been installed, has the PLG-EF parameter in the EFF Part screen of the Performance been set
to something other than OFF? (Page 117)
• If an Effect Plug-in Board has been installed, has the setting in the EFF Plg screen of the Performance been set to something
other than “THRU”? (Page 118)
The Element switches do not work for the Control Set
• Have Element-specific parameters been selected as Dest (Destination)? (Page 75)
The Plug-in Board does not work.
• Has the Effect Plug-in Board been installed in PLG2? (Page 148)
• Has the Multi-Part-type Plug-in Board been installed in PLG1? (Page 148)
• If an Effect Plug-in Board has been installed, has the PLG-EF parameter in the EFF Part screen of the Performance’s
Common Effect been set to something other than “off”? (Page 118)
• If an Effect Plug-in Board has been installed, has the setting in the EFF Plg screen of the Performance’s Common Effect been
set to something other than “THRU”? (Page 118)