Filter
Top Products
4 Remove the tape which is used to fasten the cable to the
plate.
5 Take out the Plug-in board from the anti-static bag.
When installing the board, the side with a connector and
ICs must be on top.
6 Mount the Plug-in board onto the plate as detailed in the
following steps.
6-1 Insert one side of the Plug-in board (the side
opposite to the connector) into the hooks 1 as
shown in the illustration.
6
-2 Press down the other side until it is securely
settled on the hooks 2.
Hooks 2
Hooks 2
Hooks 1
Hooks 1
tape
6-3 Carefully plug the cable connector into the Plug-in
board connector until the two notches on the
cable connector lock into the sockets on the board.
Removing the Plug-in board from the keyboard
1 Pull out the cable connector from the Plug-in board
connector.
2 Press down the hooks 2 in the direction as shown in the
illustration and take the board out from the hooks 2 by
lifting up the one side.
3 Pull out the other side of the board from the hooks 1.
149
Appendix