Filter
Top Products
YDP-223 Detailed Settings – [FUNCTION]
ENGLISH
42
Program Change ON/OFF
Normally the YDP-223 will respond to MIDI program
change numbers received from an external keyboard or
other MIDI device, causing the correspondingly-num-
bered voice to be selected on the corresponding channel
(the keyboard voice does not change). The YDP-223 will
normally also send a MIDI program change number
whenever one of its voices is selected, causing the corre-
spondingly-numbered voice or program to be selected
on the external MIDI device if the device is set up to
receive and respond to MIDI program change numbers.
This function makes it possible to cancel program
change number reception and transmission so that
voices can be selected on the YDP-223 without affecting
the external MIDI device.
Setting range: ON/OFF
Normal setting: ON
Control Change ON/OFF
Normally the YDP-223 will respond to MIDI control
change data received from an external MIDI device or
keyboard, causing the voice on the corresponding chan-
nel to be affected by pedal and other “control” settings
received from the controlling device (the keyboard voice
is not affected).
The YDP-223 also transmits MIDI control change infor-
mation when the pedal or other appropriate controls are
operated.
This function makes it possible to cancel control change
data reception and transmission so that, for example, the
YDP-223’s pedal and other controls can be operated
without affecting an external MIDI device.
Setting range: ON/OFF
Normal setting: ON
MIDI Transmit Transpose
This function allows the MIDI note data transmitted by
the YDP-223 to be transposed up or down in semitone
increments by up to plus or minus 12 semitones. The
pitch of the YDP-223 itself is not affected.
Setting range: -12 – 0 – 12 (in semitones)
Normal setting: 0
Panel/Status Transmit
This function causes all the current YDP-223 panel set-
tings (selected voice, etc.) to be transmitted via the MIDI
OUT terminal. This is particularly useful if you will be
recording performances to a MIDI sequence recorder,
such as the Yamaha MIDI Data Filer MDF3, which will
be used to control the YDP-223 on playback. By trans-
mitting the YDP-223 panel settings and recording them
on the MIDI sequence recorder prior to the actual per-
formance data, the YDP-223 will be automatically
restored to the same settings when the performance is
played back.
Procedure
1. Set up the panel controls as desired.
2. Connect the YDP-223 to a sequencer via MIDI, and
set up the sequencer so it can receive the setup data.
3. Engage Function mode and select .
4. Press the [+/YES] button to transmit the panel/status
data.
will appear on the LED display when the data has
been successfully transmitted.
TIP
For information on program change numbers for each of the
YDP-223’s voices, refer to page 61 in the MIDI Data Format
section.
TIP
For information on control changes that can be used with the
YDP-223, refer to the MIDI Data Format on page 61.
TERMINOLOGY
Setup Data:
Data that contains a set of panel settings for the YDP-223.
TIP
See page 62 for a list of the “Panel Data Contents” transmit-
ted by this function.
TIP
Receiving the transmitted data:
1. Connect the YDP-223 via MIDI to the device to which the
setup data was transmitted previously.
2. Start sending the setup data from the device.
The YDP-223 automatically receives the setup data, which
will be reflected in the panel settings.
(For the data to be accepted, the YDP-223 that receives the
setup data should be the same model as the one that trans-
mitted the setup data to the sequencer.)
TIP
For more information on transmitting and receiving setup
data via MIDI, refer to the owner’s manual for the connected
MIDI device.