Yamaha YDP-223 Musical Instrument User Manual


 
YDP-223 Connections
ENGLISH
48
Connecting a Personal Computer
You can enjoy computer music data on the YDP-223 by connecting a computer to the TO HOST (or
MIDI) jack.
There are three methods by which to connect the YDP-223 to a personal computer:
1. Connect the serial port on the computer to the YDP-223’s TO HOST jack (page 49).
2. Use a MIDI interface and the YDP-223’s MIDI connectors (page 50).
3. Use the USB port on the computer and the UX16, UX96, or UX256, a USB interface (page 51).
For more information, refer to the specified pages.
NOTE
When the YDP-223 is used as a tone module, performance data with voices that are not found on the YDP-223 will not
be played correctly.
“The Clavinova-Computer Connection,” is a supplementary guidebook that describes, for beginners, what you
can do with your YDP-223 and a personal computer and how to set up a YDP-223-Computer system (although the
guidebook only mentions the Clavinova, it applies equally to the YDP-223 digital piano). The document is available
as a PDF file (in English) at the following Internet address:
Clavinova Web site (English only):
http://www.yamahaclavinova.com/
Yamaha Manual Library:
http://www2.yamaha.co.jp/manual/english/
NOTE
When connecting the YDP-223 to a personal computer, first turn off the power to both the YDP-223 and the computer
before you connect any cables or set the HOST SELECT switch. After making the connections and switch settings, turn
on the power to the computer first, then to the YDP-223.
NOTE
If you do not use the [TO HOST] jack of the YDP-223, make sure you disconnect the cable from the jack. If the cable is
left connected, the YDP-223 may not function properly.
NOTE
will appear in the display if the host computer is not turned on, the connecting cable is not properly connected,
the HOST SELECT switch is not in the proper position, or the MIDI driver or MIDI application is not active. In this situa-
tion, turn the power off to both the YDP-223 and the computer, and check the cable connection and the position of the
HOST SELECT switch. Once the connection and HOST SELECT switch position is verified, turn the power of the com-
puter on first, then the YDP-223, and check whether the MIDI driver and MIDI application function properly.
NOTE
When the [HOST SELECT] switch is set to “PC-1,” PC-2,” or “Mac,” you can use the [TO HOST] jack, but the MIDI con-
nectors are disabled since no data transfer occurs via the MIDI connectors. On the other hand, when the [HOST
SELECT] switch is set to “MIDI,” you can use the MIDI connectors, but not the [TO HOST] jack since no data is trans-
ferred via the [TO HOST] jack.