Filter
Top Products
53
NEXT
Effect Types and Parameters
089
MonoSynth
This effect produces the sound of a monophonic (single-note playing) guitar synthesizer
that detects the pitch of the input signal.
Knob1 Knob2 Knob3
Page01
Synth 0–100 P Dry 0–100 P Level 0–150 P
Adjusts synthesizer sound level. Adjusts level of original sound. Adjusts the output level.
Page02
Wave
Sine, Tri, SawUp,
SawDn
Tone 0–10 Speed 0–100 P
Sets waveform. Adjusts the tone.
Adjusts smoothness of pitch change.
090 Z-Organ This effect simulates an organ sound.
Knob1 Knob2 Knob3
Page01
Upper 0–100 P Lower 0–100 P Dry 0–100 P
Adjusts volume of high frequencies. Adjusts volume of low frequencies. Adjusts level of original sound.
Page02
HPF 0–10 LPF 0–10 Level 0–150 P
Adjusts high-pass filter cutoff frequency.
Adjusts low-pass filter cutoff frequency.
Adjusts the output level.
091 AutoPan This effect cyclically moves the panning position of the sound.
Knob1 Knob2 Knob3
Page01
Rate 0 – 50
P Width L50 – R50 P Level 0–150 P
Sets the speed of the modulation. Sets the width of the panning. Adjusts the output level.
Page02
Depth 0–10 P Clip 0–10 P
Sets the depth of the modulation.
Adjusts the amount of waveform
clipping. Higher values emphasize
the auto-panning effect more.
092 Rt Closet Simulates a rotary speaker.
Knob1 Knob2 Knob3
Page01
Bal 0–100 P Mode Slow,Fast P Level 0–150 P
Adjusts the balance between the
horn (high frequencies) and the drum
(low frequencies).
Sets the rotary mode. Adjusts the output level.
Page02
Drive 0–100
Adjusts the amount of amplification
from the preamp.
093 Delay This long delay has a maximum length of 5000 mS. FS
Hold, InputMute
Knob1 Knob2 Knob3
Page01
Time 1–5000
F.B 0–100 P Mix 0–100 P
Sets the delay time. Adjusts the feedback amount.
Adjusts the amount of effected sound
that is mixed with the original sound.
Page02
HiDMP 0–10 P-P MONO, P-P Level 0–150 P
Adjusts the treble attenuation of the
delay sound.
Sets delay output to mono or ping-
pong.
Adjusts the output level.
094 TapeEcho
This effect simulates a tape echo. Changing the "Time" parameter
changes the pitch of the echoes.
FS InputMute
Knob1 Knob2 Knob3
Page01
Time 1–2000
P F.B 0–100 P Mix 0–100 P
Sets the delay time. Adjusts the feedback amount.
Adjusts the amount of effected sound
that is mixed with the original sound.
Page02
HiDMP 0–10 Level 0–150 P
Adjusts the treble attenuation of the
delay sound.
Adjusts the output level.
095
ModDelay This delay effect allows the use of modulation.
FS InputMute
Knob1 Knob2 Knob3
Page01
Time 1–2000
F.B 0–100 P Mix 0–100 P
Sets the delay time. Adjusts the feedback amount.
Adjusts the amount of effected sound
that is mixed with the original sound.
Page02
Rate 1–50 P Level 0–150 P
Sets the speed of the modulation. Adjusts the output level.