Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration en | 403
48.3 AVC calibration
The Audio Processing page of an audio input that has been
configured as an AVC input shows a Start AVC
calibration button (see figure 48.2) after:
1 The audio input has been set to AVC.
2 The system has been restarted.
The Start AVC calibration button starts the AVC
calibration (see chapter 49).
figure 48.2: AVC calibration button
Note
Do not forget to submit the changes. The
changes are not permanent until the
configuration is saved (see section 40.4.4 and
section 40.4.5).
Note
The AVC calibration requires the Wobble tone
to be present in the tone set. If necessary, use
Activate new tone set (see section 44.4).
