Milling Defects
Occasional defects in flooring from mis-milling or handling damage do occur. While all Indusparquet
®
flooring is supplied in
a clear grade, similar to NOFMA’s guidelines for oak flooring, standard trade practice allows for up to 5% of the square
footage to contain wood below grade and/or with milling defects. Order 5% to 7% more material than needed, allowing
for waste from crosscutting and fitting pieces on-site, as well as crosscutting out defects.
During installation, occasional knots and defects will be encountered including machining snipes, wanes, splits, and areas
on the face that will not clean up. Simply crosscut out the defects and use the remaining sections to start or finish a row.
If your installer discovers a reoccurring problem, or determines the waste to be excessive, stop immediately and call the
service department at BR-111
™
, toll free 800-525-2711 to review the problem before proceeding. BR-111
™
will, at its option,
either send replacement flooring, credit you for that portion of flooring which fails to make grade, or refund the cost of the
flooring in full. DO NOT install defective flooring. You will be the final judge of acceptable quality. Flooring that has been
installed is deemed to be acceptable.
B R -111
™
shall not be responsible for costs associated with installing, finishing, and/or replacing of flooring installed with
obvious defects.
Color & Grain Variation
Wood is a natural material. No two pieces are the same. No two trees are the same. And the same species can vary, based
on the geographic area from which it was harvested. BR-111
™
cannot be responsible for claims arising from flooring that
possesses a greater range of grain/color variation than found in samples supplied by dealers.
Color Fastness
All woods are sensitive to light and/or oxygen, and over time, will change color, developing a unique patina. Native
species, such as cherry, darken over time. Walnut, on the other hand lightens. In general, water based finishes tend to
inhibit the degree of change, while oil based finishes allow a more pronounced change to occur.
Terms and Conditions
The terms of this warranty become valid upon final payment and successful installation of the product. The use of floor care
products other than those recommended by BR-111
™
may damage flooring and void this warranty. Inquiries regarding this
warranty should be directed to the BR-111
™
retailer where the original purchase was made. If the retailer is unable to satisfy
your request, contact in writing the customer service department at BR-111
™
.
EXCEPT AS EXPRESSLY SET FORTH ABOVE, BR-111
™
MAKES NO WARRANTY, EXPRESS OR IMPLIED, WHETHER RELATING TO
MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE OR OTHERWISE, AND BR-111
™
DISCLAIMS ALL WARRANTIES NOT
EXPRESSLY SET FOR THE ABOVE.
33
33
//
//
44
44
""
""
,,
,,
55
55
//
//
11
11
66
66
""
""
&&
&&
77
77
//
//
11
11
66
66
""
""
PP
PP
RR
RR
EE
EE
FF
FF
II
II
NN
NN
II
II
SS
SS
HH
HH
EE
EE
DD
DD
SS
SS
OO
OO
LL
LL
II
II
DD
DD
WW
WW
AA
AA
RR
RR
RR
RR
AA
AA
NN
NN
TT
TT
YY
YY
41
(800) 525-BR111(2711)
•
Fax (800) 577-2711
•
www.br111.com
Indusparquet
®
(continued)
8/30/04
