Proper Method To Equalize Flooring
The following steps should be taken by your installer to insure proper equalization.
1. Establish the target job-site equilibrium point by taking into account location and heating/air condition systems.
2. Moisture meter hardwood flooring on-site. Stabilize the target equilibrium point by drying on-site, or allowing the
material to pick up additional moisture.
3. Moisture meter the sub-floor. Sub-floors that are too wet can cause cupping, swelling, and compressions to the
hardwood installation.
4. Monitor relative humidity on the job-site. It is best to have all heating/air conditioning units operating at least one week
prior to installation.
5. Based on the tests above, remove the flooring from its packaging and spread throughout the job-site, allowing the
material to reach its target equilibrium point. Continue to monitor the moisture content and allow the flooring to stand
on-site until desired point is reached.
6. Avoid excessive seasonal swings in relative humidity using heating/air conditioning and other humidity control systems.
7. Use only a slightly damp mop when cleaning floors. NEVER soak flooring.
8. Save the results of moisture readings during installation for use in identifying the cause of any future problems.
Indusparquet
®
warrants moisture content, posted on packing list, at the time of shipping only. Installers must monitor
moisture content of materials upon arrival on-site and immediately notify BR-111
™
if there is a discrepancy in moisture
content. (BEFORE INSTALLATION)
Proper on-site equalization of flooring is the responsibility of the installer. BR-111
™
shall not be responsible for shrinkage or
movement after the installation is complete.
(continued)
54
(800) 525-BR111(2711)
•
Fax (800) 577-2711
•
www.br111.com
II
II
NN
NN
SS
SS
TT
TT
AA
AA
LL
LL
LL
LL
AA
AA
TT
TT
II
II
OO
OO
NN
NN
GG
GG
UU
UU
II
II
DD
DD
EE
EE
LL
LL
II
II
NN
NN
EE
EE
SS
SS
Indusparquet
®
8/30/04
