Configuration Menu 90
You can view all pending configuration changes that have been applied but not saved to flash memory using the diff
flash command. It is a global command that can be executed from any prompt.
For instructions on selecting the configuration to run at the next system reset, see the “Selecting a configuration block”
section in the “Boot Options Menu” chapter.
Reminders
CLI reminders prompt users to complete configuration tasks that require multiple steps. The default setting for CLI
reminders is enabled. Use the following command to disable CLI reminders: /cfg/sys/reminders dis
The following is an example of a configuration task performed with CLI reminders enabled.
>> Layer 2# vlan 5
VLAN number 5 with name "VLAN 5" created.
Reminder: VLAN 5 needs to be enabled.
>> VLAN 5# add 9
Port 9 is an UNTAGGED port and its current PVID is 1.
Confirm changing PVID from 1 to 5 [y/n]: y
Current ports for VLAN 5: empty
Pending new ports for VLAN 5: 9
Reminder: Port 9 needs to be enabled.
Reminder: VLAN 5 needs to be enabled.
System configuration
Command: /cfg/sys
[System Menu]
syslog - Syslog Menu
sshd - SSH Server Menu
radius - RADIUS Authentication Menu
tacacs+ - TACACS+ Authentication Menu
ntp - NTP Server Menu
ssnmp - System SNMP Menu
access - System Access Menu
date - Set system date
time - Set system time
timezone - Set system timezone (daylight savings)
idle - Set timeout for idle CLI sessions
notice - Set login notice
bannr - Set login banner
hprompt - Enable/disable display hostname (sysName) in CLI prompt
bootp - Enable/disable use of BOOTP
dhcp - Enable/disable use of DHCP on Mgmt interface
reminders - Enable/disable Reminders
cur - Display current system-wide parameters
This menu provides configuration of switch management parameters such as user and administrator privilege mode
passwords, browser-based management settings, and management access list.
The following table describes the System Configuration Menu options.
Table 78 System Configuration Menu options
Command Usage
syslog Displays the Syslog Menu.
sshd Displays the SSH Server Menu.
radius Displays the RADIUS Authentication Menu.
tacacs+ Displays the TACACS+ Menu.
ntp Displays the Network Time Protocol (NTP) Server Menu.
ssnmp Displays the System SNMP Menu.
access Displays the System Access Menu.
