234
Chapter 18 CD-R Backup
Items Necessary for CD-R Backup
• VS-1824
• Blank CD-R (Compact Disc-Recordable) or CD-RW
(Compact Disc-Rewritable) disc
* You cannot use high-speed compatible
CD-RW discs. This mark is printed on
high-speed compatible CD-RW discs.
It is recommended to use CD-R discs from the following
manufacturers.
Taiyo Yuden Co., TDK Co., Mitsui Chemicals Co.,
Mitsubishi Chemicals Inc., Ricoh Co.,Ltd,
Hitachi Maxell Ltd.
It is recommended to use CD-RW discs from the
following manufacturers.
Ricoh Co., Ltd, Mitsubishi Chemicals Inc.
Recommended CD-R/CD-RW discs (approved by Roland)
are shown in the owner's manual of the CD-R/RW drive.
If you are using a VS-1824 that is not equipped
with an internal CD-RW drive, you will need to purchase a
separately available CD-RW drive (approved by Roland). For
instructions on connecting the drive, refer to “Connecting an
External CD-R/CD-RW Drive” (p. 194).
Inserting a CD
1. Press the eject button and open a disc tray.
2. Pull out a disc tray.
3. Locate the position of center hole of CD at stopper of
CD-RW drive.
4. Press the CD downward. The CD will be locked by 3
clips of the stopper.
5. Press disc tray until it is locked in the VS-1824.
If a disc tray does not open
If the power is turned off with the disc still in the drive
(such as due to a power failure), the disc tray cannot be
opened by pressing the eject button. In this case, you can
insert a piece of wire to force the tray open.
It is strictly restricted to eject tray using emergency eject
hall during VS-1824 is operating. This is cause error of
software.
1. Turn off the power of the VS-1824.
2. Insert a thin object such as a wire into the emergency
eject hole. The disc tray will open.
Emergency Eject Hole
