253
Chapter 21 System and Global Settings
Chapter 21
Measure Display
VS-1824 can show measure and beat while it is sending MIDI
clock. About MIDI clock, see “Sync Gen.” on p. 198. VS-1824
can send MIDI clock in case “Sync Gen.” setting is
“MIDIClk” or “SyncTr.”
1. Hold [SHIFT] and press [F5 (SYSTEM)].
The System Menu icon is displayed.
If the System Menu icon does not appear, press [F6 (EXIT)].
2. Press [F2 (GLOBL)].
If “GLOBL” does not appear above [F2], first press [PAGE]
until “GLOBL” appears, and then press [F2 (GLOBL)].
3. Use [ ], [ ], [ ], and [ ] to move the
cursor to “Measure Display.”
4. Use the TIME/VALUE dial to change the setting to
“Auto”.
Measure Display
Use this to select whether or not the measures and beats
appear in the graphic display.
Always:
The measure and beat are always displayed.
Auto:
The measure and beat are not displayed when the
MIDI clock is not sending.
5. Press [PLAY (DISPLAY)] to return to the Playlist display.
Example of entering numerals with “Up”
Setting
This example explains how “01h23m45s00f” is entered
when the NUMERICS Type is “Up”.
1. Press [NUMERICS]. The button indicator lights.
2. The cursor appears at the digit furthest to the right
(the lowest digit place). Press the LOCATOR buttons
[1], [2], [3], [4], [5], and [SCENE/0] (four times), in
that order.
The numerals appear in the place furthest to the
right and shift to higher places as other numerals are
entered. You can also move the cursor to the desired
place by pressing [ ] and [ ].
3. When you are finished entering the numerals, press
[ENTER/YES]. The numerical value is set, and the
button indicator goes off.
Example of entering numerals with
“Down” Setting
This example explains how “01h23m45s00f” is entered
when the NUMERICS Type is “Down”.
1. Press [NUMERICS]. The button indicator lights.
2. The cursor appears at the digit furthest to the left
(the highest digit place). Press the LOCATOR
buttons [SCENE/0], [1], [2], [3], [4], [5], [SCENE/0],
and [SCENE/0], in that order.
The numerals appear from left to right, just as they are
entered. You can also move the cursor to the desired
place by pressing [ ] and [ ].
3. When you are finished entering the numerals, press
[ENTER/YES]. The numerical value is set, and the
button indicator goes off.
