© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-811DRU
42
• Remote Control: Select enable or disable for the feature.
• Port: Enter the port to assign remote access to the router. It is recommended to
leave this setting as 8080.
Note: If you have configured port 8080 for another configuration section such
as virtual server or special application, please change the port to use.
(Recommended port range 1024-65534)
Prioritize traffic using QoS (Quality of Service)
Network > QoS
You may want to prioritize traffic for specific computers or devices on your network to
have higher priority. QoS involves prioritization of network traffic. QoS can be targeted
at a network interface, toward a given server or router's performance, or in terms of
specific applications.
1. Log into your router management page (see “Access your router management page
”
on page 31).
2. Click on Network, and click on QoS.
3. Review the QoS settings.
• Enable QoS: Enable or Disable the Quality of service through the router.
• Prioritize ACK: Enable or disable ACK prioritization.
• Prioritize ICMP: Enable or disable ICMP prioritization.
3. Select the traffic class you would like to configure for your QoS rule.
4. Review the Inbound/Outbound Class Setting section.
• BW Max Inbound: Enter the maximum download speed of your ISP (Internet
Service Provider).
• Highest/High/Medium/Low/Lowest: Enter the download speeds you would like
to apply on each state of download speeds. This setting is similar to setting the
priority speeds of each class
