Turbonetics P/N 15152 Manual

A SERVICE OF

next previous

60133 revG Page 12 of 38

2. Carefully lift the mass air sensor out of the factory air box and set it aside. You will be re-installing the

sensor on a supplied intake pipe at a later time.

3. Remove the engine breather hose by pinching the tabs on the hose clamps with your finger or a pair of

pliers and push the clamp away from the motor. SEE FIGURE 21

FIGURE 21

4. Loosen hose clamp that connects the intake tube to the air box. SEE FIGURE 22

FIGURE 22

5. Remove the factory intake tube that connects to the throttle body by pinching the tabs on the hose clamp

with a pair of pliers. SEE FIGURE 23

FIGURE 23