Turbonetics P/N 15152 Manual

A SERVICE OF

next previous

60133 revG Page 18 of 38

Turbo Oil Drain

1. Using the supplied center punch (P/N #21273) and a hammer, punch a hole through the oil pan. Do not

use a drill, by using a center punch, the material that bends over is used for threading. SEE FIGURE 39,

40, & 41

FIGURE 39

FIGURE 40 FIGURE 41

2. Coat the supplied 3/8” NPT tap (P/N #30809) with grease to insure no metal debris will enter the pan and

tap the hole you just made. SEE FIGURE 42

FIGURE 42

~2.25”

~1.0”