A SERVICE OF

logo

Open as PDF
next previous
60133 revG Page 19 of 38
3. Apply a small amount of high temp RTV to the threads of the supplied 3/8” NPT to 5/8” barb brass fitting
(P/N #30133) and the threads in the oil pan as shown in the picture below. Thread the fitting into the pan
and tighten. SEE FIGURES 43, 44, & 45
FIGURE 43 FIGURE 44
FIGURE 45
Assembling the Turbo and Mounting it to the Manifold
1. Thread the four supplied M10x1.25 studs (P/N #30806) onto the turbo mounting pad on the manifold.
SEE FIGURE 46
FIGURE 46
EXHAUST MANIFOLD P/N #21279
TURBO MOUNTING
FLANGE
FITTING P/N #30133