60133 revG Page 25 of 38
FIGURE 59
3. The bottom brackets of the intercooler should both line up with the existing mounting holes. When re-
installing the front fascia later, the factory bolts will bolt the intercooler to the core support.
4. Slide the supplied 6.50” long silicone hose (P/N #21364) on to pipe #21240. SEE FIGURE 60 & 61
5. Using a 2.50” (P/N #30172-4) silicone hose, connect the pipe to the intercooler, making sure the end with
the 6.50” long silicone hose (P/N #21364) goes through the space between the front engine mount and
the center core support reinforcement bar. SEE FIGURE 61. Secure the pipe to the intercooler using the
supplied 2.50” (P/N #30275-250) t-bolt clamps. Do not completely tighten the clamps at this point, tighten
clamps just enough to keep the pipe in its place.
FIGURE 60 FIGURE 61
6. Slide the supplied 2.0” diameter silicone hose (P/N #30128-4) onto the elbow of the compressor housing
along with two 2.0” t-bolt clamps (P/N #30275-200). Connect intercooler pipe assembly (P/N #21239)
onto the other end. Using a 2.0” silicone hose (P/N #30128-4) connect the shorter end of the pipe to the
intercooler. Secure pipe to intercooler using supplied 2.0” t-bolt clamps (P/N #30275-200). SEE FIGURE
62, 63, & 64.
SIDE TO
INTERCOOLER
PIPE P/N #21240
