Alesis QS8 Musical Instrument User Manual


 
Overview: Chapter 4
COPYING SOUNDS BETWEEN PROGRAMS
Follow the steps below to copy one of the four Sound layers from one Program to
another Program in the User Bank. When copying Sounds between Programs, the
"new" Sound will replace the same numbered Sound in the destination Program, i.e.,
Sound 3 will replace Sound 3.
¿ Press [PROGRAM] to select Program Play Mode, then use the [s VALUE] and
[VALUE t] buttons to select the Program Number that uses the Sound you want
to copy. If necessary, use the [ BANK] and [BANK ] buttons to select a
different Bank.
¡ Press [STORE].
¬ Press [PAGE ] once to advance to Page 2.
The upper section of the display will read “COPY SOUND 1”.
Use the [s VALUE] and [t VALUE] buttons to select which Sound (1–4) you wish
to copy from the currently select Program.
ƒ Press [PAGE ] once to advance the cursor to the Program number value in the
lower section of the display.
Use the [s VALUE] and [VALUE t] buttons or move the CONTROLLER [D] slider
to select the Program Number in the User Bank you wish to copy the Sound to
(000–127). Or, you may copy into any of the four Sounds of the source Program
(Sound 1-4).
Press [STORE] to complete the copy function.
COPYING EFFECTS BETWEEN PROGRAMS
Follow the steps below to copy the Effects from one Program to another Program in
the User Bank.
¿ Press [PROGRAM] to select Program Play Mode, then use the [s VALUE] and
[VALUE t] buttons to select the Program Number that uses the Effects you want
to copy. If necessary, use the [ BANK] and [BANK ] buttons to select a
different Bank.
¡ Press [STORE].
¬ Press [PAGE ] once to advance to Page 2.
The upper section of the display will read “COPY SOUND 1”.
Press the [s VALUE] button four times until the display reads “COPY EFFECT”.
This selects the Effects of the currently selected Program as the source of what
is to be copied.
ƒ Press [PAGE ] once to advance the cursor to the Program number value in the
lower section of the display.
Use the [s VALUE] and [VALUE t] buttons or move the CONTROLLER [D] slider
to select the Program Number in the User Bank you wish to copy the Effects to
(000–127).
Press [STORE] to complete the copy function.
QS7/QS8 Reference Manual 37