Filter
Top Products
Chapter 6: Editing Programs
FILTER ENVELOPE
The Filter Envelope function (press [100]) is crucial whenever you want the tonal
quality of a note to change over time, differently from its overall level. Example: When
you want the initial attack of a note to be bright, but want the sustaining part to be
filtered.
J
The following Filter Envelope variables will have effect only if the FILTER
ENVELOPE DEPTH (on Page 7 of the FILTER function) is set to a value other than
0, or, Filter Envelope is a source in the MOD function.
Also note that the Filter Envelope may have no effect if some other modulation
source, or the basic setting of the filter, has already pushed the filter cutoff frequency
to its maximum.
Attack (00 to 99) Page 1
This is the amount of time the envelope will take until it reaches its maximum output
level. Setting the Attack to 0 will give a sharp edge to the sound (if the Delay is also
set to 0 in Filter Envelope Page 5 -- see next page); a setting of 99 will result in a
much slower attack, taking many seconds before the envelope gets to maximum.
Decay & Sustain (00 to 99) Pages 2 & 3
As soon as the attack portion of the envelope finishes (when the level reaches
maximum), the envelope will decay (decrease in level). The level it reaches is set by
the Sustain control; how long it takes to get there is set by the Decay control. In the
special case where the Sustain level is all the way up (99), then there is no decrease
and the Decay time segment is bypassed. Whatever level the sustain is set to is the
level that the decay section of the envelope will head for. Depending on the setting of
the Sustain Decay control (see below), the envelope will either hold at the sustain
level until you release the note on the keyboard, or decay to 0 at the Sustain Decay
rate (which is on page 2 of the envelope). You can create a long “plateau” at the start
of a note by setting the Sustain to 98 and the Decay to 99. This will cause the
envelope to take the maximum amount of time to get from peak level to a level of 98,
before the Sustain Release portion of the envelope begins.
Release (00 to 99) Page 4
Eventually, you will let go of the note that you’ve been holding (either by releasing the
note on the keyboard, or releasing the sustain pedal if it was pressed). It is at this
point that the Release portion of the envelope takes effect. The Release is the time
that the envelope takes to get from the sustain level back down to nothing. Setting
the Release time to 0 is good for playing those short funky riffs that you hear on a
clavinet. Setting the Release time to 99 will take the envelope a very long time to
reach zero level.
68 QS7/QS8 Reference Manual