Filter
Top Products
48
Chapter 5 Setting the Pedal Functions (Pedal Assign)
Controlling Effects with the GT-6B Pedals,
External Pedals, and External MIDI Devices
Make these settings when controlling effects with the GT-
6B’s expression pedal, expression pedal switch, or CTL
pedal, or with external pedals or external MIDI devices
connected to the GT-6B.
You can make up to eight separate settings per patch (using
Assign numbers 1–8) determining what parameters are
controlled by which controllers.
fig.05-08
1. Press [PEDAL ASSIGN].
2. Press PARAMETER [ ] [ ] to display the
following screen.
fig.05-09
3. Rotate the VALUE dial to change the setting value.
4. Repeat Steps 2 and 3 as needed until the settings are
completed.
5. To save the settings, use the Write procedure (p. 23).
Press [EXIT] to return to the Play screen.
Making the Assign On/Off Setting
fig.05-10
This selects the eight Assign ON/OFF settings (ASSIGN 1–8).
Only set the assigns you will be using to “On.”
* Be sure to set any Assign settings not being used to “Off.”
1. Press [PEDAL ASSIGN].
2. Press PARAMETER [ ] [ ] to select the Assign
ON/OFF setting screen (ASSIGN 1–8).
3. Press [PEDAL ASSIGN] to set the function to ON or
OFF.
The setting is toggled between “On” and “Off” each time
[PEDAL ASSIGN] is pressed.
Making Settings Instantly
(Quick Settings)
Using Quick Settings lets you quickly finish making the
settings to the parameters described below, without having
to set them all individually.
As you rotate the PATCH/VALUE dial in the Quick Setting
screen to select the prepared pedal settings, the most
appropriate values for related parameters are selected
instantly.
• PATCH LEVEL
• PREAMP GAIN
• OD/DST DRIVE
• DELAY LEVEL
• CHORUS LEVEL
• REVERB LEVEL
• MASTER BPM
• SUB EXP FV
Controlling Foot Volume with the External Expression
Pedal
• SUB EXP PS
Controlling Pitch Shifter with the External Expression
Pedal
1
3
2
Assign On/Off
Quick Setting
Target
Target value range: Min
Target value range: Max
Sourece
Source Mode
Active Range Low
Active Range High