Filter
Top Products
63
Chapter 9 Other Functions
Chapter
9
Setting the Knob Functions
(Knob Mode)
This sets the way the values of settings are changed when the
control knobs are turned.
1. Press [UTILITY], then press PARAMETER [ ]
[ ] so that “Knob Mode” is displayed.
fig.09-07
2. Rotate the PATCH/VALUE dial to set the Knob mode.
Immediate:
Turning the knobs immediately changes the values.
Current Setting:
Values begin to change only once the knob position
reaches the values set in the patch.
3. Press [EXIT] to return to the Play screen.
Setting the External Foot Switch
Functions (SUB CTL 1, 2 Function)
This sets the foot switch functions for “Sub Control 1” and
“Sub Control 2” when you have an external foot switch
connected to the rear panel’s SUB EXP PEDAL/SUB CTL1,2
jack.
* When connecting two foot switches using the special optional
Roland PCS-31 connector cord, the foot switch connected
using the plug with the white stripe functions according to the
Sub Control 1 settings, and the foot switch connected using
the plug with the red stripe functions according to the Sub
Control 2 settings.
* When you have only one foot switch connected, the Sub
Control 1 settings are used.
1. Press [UTILITY], then press PARAMETER [ ]
[ ] so that “SubCTL 1 Func” or “SubCTL 2 Func” is
displayed.
fig.09-08
2. Rotate the PATCH/VALUE dial to set the function for
the foot switch.
Assignable:
The controller set in each patch’s Pedal Assign (p. 46) is
used.
Bypass On/Off:
The foot switch is used as a bypass On/Off switch.
Patch Select:
The foot switch is used for switching Patch Select mode
(p. 60).
MIDI Start/Stop:
The foot switch is used for starting and stopping an
external MIDI device (such as a sequencer).
MMC Play/Stop:
The foot switch is used for controlling Play and Stop for
the external MIDI device (such as a hard disk recorder).
3. Press [EXIT] to return to the Play screen.