Filter
Top Products
51
Chapter 5 Setting the Pedal Functions (Pedal Assign)
Chapter
5
Active Range
fig.05-18
When an expression pedal or other controller that changes
the value consecutively is used as the source, this sets the
operational range within which the value of the setting
changes. If the controller is moved outside the operational
range, the value does not change, but instead stops at
“minimum” or “maximum.”
(Example) Act. Range Lo: 40, Act. Range Hi: 80
fig.05-19a
fig.05-19b
* When using a foot switch or other on/off switching controller
as the source, leave these at “Lo: 0” and “Hi: 127.” With
certain settings, the value may not change.
Controlling Foot Volume and Pitch Shifter
with an External Expression Pedal
Make the following settings to use an expression pedal
connected to the SUB EXP PEDAL/SUB CTL 1,2 jack to
control foot volume and pitch shifter.
* Set SYS: Sub CTL1 Func (p. 63) to “Assignable.”
1. Press [PEDAL ASSIGN].
2. Press PARAMETER [ ] [ ], to display one of the
Assign On/Off screens for ASSIGN 1–8.
fig.05-10
* When the upper row of the screen indicates “OFF” (flashing),
press [PEDAL ASSIGN] to set it to “ON” (lit).
3. Rotate the PATCH/VALUE dial to select the following
settings:
For Foot Volume:
SUB EXP FV
For Pitch Shifter:
SUB EXP PS
fig.05-20
4. If Pitch Bend has been selected in Step 3, carry out the
following.
Press [FX-2] so that “On” appears in the display.
Next, press PARAMETER [ ] [ ] to display “FX
Select,” then select “P.S” with the PATCH/VALUE dial.
04080
127
maximum value
Target Max
minimum value
Target Min
Act. Range
Lo
Act. Range
Hi
OFF
On
Off
Center
value
ON
0408060
127
Act. Range
Max
Act. Range
Lo