Filter
Top Products
E-28
Applying Effects to Tones
SRv072 T ime
4
Use the [+] and [–] buttons or the number buttons
to scroll through the reverb types until the one you
want is displayed, or use the number buttons to
input the reverb number you want to select.
• See the separate
Appendix
F for information about
the reverb types that are available.
• Here you could also change the parameters of the
effect you selected, if you want. See “Changing the
Settings of REVERB Parameters” for more
information.
Changing the Settings of REVERB
Parameters
You can control the relative strength of a reverb and how it is
applied. See the following section titled “REVERB
Parameters” for more information.
1
After selecting the reverb type you want, use the
[̇] and [̈] CURSOR buttons to display the
parameter whose setting you want to change.
• This displays the parameter setting screen.
Example: To set the Reverb Time parameter
2
Use the [+] and [–] buttons or the number buttons
to input the parameter setting you want.
3
Press the EFFECT or EXIT button.
• This returns to the tone or rhythm selection screen.
REVERB Parameters
Reverb effects are associated with either a reverb type or delay
type. Parameter settings depend upon the associated type.
Reverb Type (No. 0 to 5, 8 to 13)
■
Reverb Level (Range: 000 to 127)
Controls the reverb size. A larger number produces larger
reverb.
■
Reverb Time (Range: 000 to 127)
Controls how long reverb continues. A larger number
produces longer reverb.
■
ER Level (Initial Echo Sound) (Range: 000 to 127)
This parameter controls the initial reverb volume. The
initial echo sound is the first sound reflected from the
walls and ceiling when a sound is output by this digital
piano. A larger value specifies a larger echo sound.
■
High Damp (Range: 000 to 127)
Adjusts the damping of high frequency reverberation
(high sound). A smaller value damps high sounds,
creating a dark reverb. A larger value does not damp high
sounds, for a brighter reverb.
Delay Type (No. 6, 7, 14, 15)
■
Delay Level (Range: 000 to 127)
Specifies the size of the delay sound. A higher value
produces a larger delay sound.
■
Delay Feedback (Range: 000 to 127)
Adjusts delay repeat. A higher value produces a greater
number of repeats.
■
ER Level
Same as Reverb Type
■
High Damp
Same as Reverb Type
NOTE
• Whether or not an effect is applied to the parts that are
sounding also depends on Mixer Mode Reverb Send,
Chorus Send, and DSP on/off settings. See “Mixer
Function” on page E-39 for more information.
Selecting CHORUS
Perform the following steps to select CHORUS.
1
Press the EFFECT button so the EFFECT indicator
appears on the display.
2
Press the [̄] CURSOR button twice.
• This displays the chorus editing screen.
• The chorus type setting screen (step 4) will appear
automatically about fives seconds after you press the
button.
3
Press the [̈] CURSOR button.
4
Use the [+] and [–] buttons or the number buttons
to scroll through the chorus types until the one you
want is displayed, or use the number buttons to
input the chorus number you want to select.
• See the separate
Appendix
G for information about
the chorus types that are available.
• Here you could also change the parameters of the
effect you selected, if you want. See “Changing the
Settings of CHORUS Parameters” for more
information.