Filter
Top Products
E-46
Creating a User Tone
Use the following procedure to select a preset tone and change
its parameters to create a user tone.
1
First, select the preset tone you want to use as a
basis for your user tone.
2
Press the SYNTH button.
• This causes the SYNTH indicator to appear on the
display.
3
Use [̇] and [̈] CURSOR buttons to display the
parameter whose setting you want to change.
• Each press of [̇] or [̈] CURSOR button changes to
the next parameter. See “Parameters and Their
Settings” on this page for information on setting range
for each parameter.
4
Use [+] and [–] to change the setting of the currently
selected parameter.
• You can also use the number buttons to input a value
to change a parameter setting. See “Parameters and
Their Settings” on this page for information on setting
range for each parameter.
5
After you are finished editing the sound, press the
SYNTH button to exit the Synthesizer Mode.
NOTE
• See “Storing a User Tone In Memory” on page E-48 for
details on saving user tone data to memory so it is not
deleted.
Synthesizer Mode
At 00 T i emk
Currently selected parameter
Parameter setting value
Vi 00 De l
y
ab
Parameters and Their Settings
The following describes the function of each parameter and
provides its setting range.
■
Attack Time (Range: –64 to 00 to +63)
Time it takes before the tone sounds after a key is pressed
■
Release Time (Range: –64 to 00 to +63)
Time the tone continues to sound after a key is released
■
Cutoff Frequency
(Range: –64 to 00 to +63)
High-band cutoff for the harmonic components of the tone
■
Resonance (Range: –64 to 00 to +63)
Resonance of the tone
At-01 Ti emk
Re-07 .Ti eml
C--06 f fF
q
ro
Re-08 ona .ns
Number buttons
[+]
/
[–]
CURSORSYNTH