Filter
Top Products
English
Operations Common to All Modes
E-11
Use the procedure below to save edited and registered
data to Digital Piano memory.
1.
Press the
eq
(WRITE) button.
2.
If the data lets you change its number or data
name, perform the procedure under “Inputting
Text Characters” on page E-10.
• You can also input numbers with the 10-key pad. For
details, see “To input a number with the 10-key pad”
in “Operations Common to All Modes” (page E-9).
• To specify a number, move the cursor to the location
where the number is located.
• To specify a name, move the cursor to the first
character of the location where the name is located.
3.
Press the
em
(ENTER) button.
This will display a confirmation message “SURE?”.
• If you want to cancel the save operation, press the
eo
(NO) or
dr
(EXIT) button.
4.
Press the
eo
(YES) button.
The message “Please Wait” will remain on the display
while the operation is being performed. Do not perform
any operation while this message is on the display.
“Complete” appears on the display after data save is
complete.
• If there is already data at the location you are saving
the new data or if there is already a file with the same
name you specified, a message “Replace?” will
appear asking if you want to overwrite the existing
data with the new data. Press the
eo
(YES) button to
overwrite or the (NO) button to cancel the save
operation.
Use the procedure below with functions that allow
playback of data.
1.
Press the button of the function you want to
use the required number of times until the
button lamp is lit.
The button of each function has a lamp. When the lamp
of a function button is lit, it means the function is
standing by for playback.
•
cm
(SONG) button: Song sequencer playback (page
E-21)
•
cq
(PHRASE) button: Phrase sequencer playback
(page E-18)
•
er
(AUDIO RECORDER) button: Audio recorder
playback (page E-23)
2.
Press the
cr
(START/STOP) button to start
playback.
3.
Press the
cr
(START/STOP) button to stop
playback.
Saving Data Starting and Stopping
Playback