Filter
Top Products
E-20
Recording and Playing Back Phrases
1.
Press the
cq
(PHRASE) button.
This displays the phrase selection screen shown below.
2.
Specify the number of the phrase you want to
hear.
• For details about how to do this, see “Changing a
Number or a Value” in “Operations Common to All
Modes” (page E-9).
3.
Use the
dt
(w) button to select “Loop”, and
then use the
eo
minus (–) and plus (+)
buttons to turn looping on or off.
4.
Play the phrase.
• For details about how to do this, see “Starting and
Stopping Playback” in “Operations Common to All
Modes” (page E-11).
• The phrase loop setting is saved as a parameter for
each phrase.
Changing the tempo setting
There are two different methods you can use to change
the tempo setting: using the TEMPO buttons or
tapping a beat with a button.
• You can use this procedure to adjust the tempo not
only for phrases, but also for other functions as well.
■ To change the tempo using the TEMPO
buttons
1.
Press the
ct
(TEMPO) button.
• This displays the tempo screen shown below.
2.
Adjust the tempo (beats per minute) value as
desired.
• For details about how to do this, see “Changing a
Number or a Value” in “Operations Common to All
Modes” (page E-9).
• You can also change the tempo value using the
dk
minus (–) and plus (+) buttons.
• You can specify a tempo value in the range of 020 to
255.
3.
Press the
dr
(EXIT) button.
This exits the tempo screen.
■ To adjust the tempo by tapping a beat
1.
Press the
ct
(TEMPO) button.
This displays the tempo screen.
2.
Tap the
ct
(TAP) button four times at the
speed (tempo) you want to set.
• The tempo setting will change in accordance with
your tapping speed as soon as you tap the fourth
time.
3.
After setting the tempo by tapping, you then
can use the procedure under “To change the
tempo using the TEMPO buttons” (page
E-20) to make fine adjustments.
Using the Phrase Selection Screen to
Select the Recommended Tone as the
Zone Part 1 Tone
• For details about zone parts, see the separate
“Tutorial”.
1.
Press the
cq
(PHRASE) button to display the
“PHRASE SELECT” screen (page E-20) for
selecting a phrase.
2.
Hold down the
dl
(BANK) button until its
lamp starts to flash.
The tone that was selected as the Zone Part 1 tone when
the data was saved is the recommended tone.
Listening to a Phrase
OFF : One-time playback
ON : Looped playback
Phrase number Phrase name
Loop setting