Filter
Top Products
35
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Operation ~ Controllers
3. Activate the telephone interface by clicking On
or by beginning to dial
.
4. Enter the number to be dialed, including any dial-out prefixes.
5. Click Send. If you clicked directly on the numbers, the call will be
completed as you finish dialing—just like using a standard telephone.
6. When you are finished with the call, click Disconnect to end the call.
Other telco options
• Hook Flash. This feature sends a momentary interruption in line seizure to
the telephone line.
• Re-Null. This feature sends a short noise burst down the telephone line and
forces the AP400 to adapt to the telephone line.
• Auto-Answer. This feature turns auto-answer on and off. If auto-answer is
turned on, the AP400 answers the call after the first complete ring. If it is
turned off, you will need to manually answer the call.
• Adapt Mode. This feature turns allows the AP400 to automatically adapt
to line conditions. Burst uses a white-noise burst to adapt the AP400 to line
conditions.
• Auto Disconnect. This feature selects which condition will trigger an auto
disconnect or disable this feature. Loop Drop will disconnect when the line is
dropped. Call Progress will disconnect the line upon detection of a valid call-
progress signal. LD + CP requires both conditions to be present.
Custom control through DB-25 port
A customer-supplied remote control or contact-closure switch can be programmed to
perform functions such as: mute on/off, system on, and system off. For pinouts, see
Appendix C, page 42.
Controllers