Filter
Top Products
7. SOFTWARE EDITOR DRM 4000
The Software Editor DRM 4000 is shipped together with the optionally available extension-kit RS-232
interface (NRS 90258). The DRM 4000 editor software runs under Windows and offers possibilities to
comfortably program and monitor the DRM 4000 on-line.
7.1 System Requirements
- PC with Pentium processor
- Microsoft Windows
TM
95 / 98 / ME / 2000 / NT
- 32 MB RAM
- Hard disk with at least 5 MB of free storage
- Mouse
- VGA-type monitor (The software is optimized for a monitor resolution of 1024x768 pixels)
- Graphic-board, 256 colors
- RS-232 interface for serial connection to the DRM 4000
7.2 Installation Notes
- Insert the setup disk “1" into the floppy drive ”A".
- Select “EXECUTE” in the Windows start menu.
- Enter the command “a:\DRM4000 Editor.exe”.
- Follow the instructions during the installation routine.
7.3 PC - DRM 4000 Connection
Check your PC for available COM-ports that are not assigned to any other application. The DRM 4000
Editor Software allows choosing between COM1 to COM8.
Use a custom RS-232 cable (5-pin D-type, plug-socket, 1:1) for connecting the chosen COM-port on your
computer to the RS-232 interface-port on the rear panel of the DRM 4000. Before establishing the
connection, make sure to switch off the power of both appliances. Otherwise, this could lead to severe
hardware damage.
SOFTWARE EDITOR DRM 4000
7-1