Filter
Top Products
Stage 3
1. Congure the system.
Follow the steps in your PoleVault installation guide to
congure the PoleVault system.
2. Set up the microphone.
(Refer to the VoiceLiftMicrophoneSetupGuide card, provided
with your microphone, for details of these procedures.)
a. Set the channels using the rotary switch.
b. Apply the Teacher or Student label to the back of the
microphone.
c. Remove the battery door and insert the battery.
d. Attach the lanyard to the rotating clip.
3. Test the system.
a. Power on all devices. The Power LEDs on the
microphone and receiver should light green.
b. Test the microphone for audio. Make sure that the
microphone is in the middle of the volume range by
pressing the Volume buttons to lower the levels all the
way down, then to raise them up six steps.
Ñ
–
Ö
Test the microphone for audio.
Extron
PWR
CHARGEOFF/MUTE/CHG ON
Volume Up
Volume Down
Power On/Off
2a
2d
2c
2b
Ç
–
ï
Set up the microphone.
VoiceLift Microphone Installation • Installation — Stage 3
2-14
Installation — Stage 3