Filter
Top Products
1-6
Introduction — Inventory Overview, cont’d
VoiceLift Microphone Installation • Introduction — Inventory Overview
b. Items not included
The following items are not included. However, some or all of these items may be needed for the installation at your
particular site.
• Additional length of RJ-45 cabling (CAT 5, 5e, or 6 with T568A or T568B straight-through wiring)
• Installation hardware (may vary by installation):
Electrical ceiling box, 3.5" or 4.0"
Junction box
Plaster ring
Raceway
Bolts for concrete structural ceilings where needed
Dry wall anchors and screws
Spare ceiling tiles in case of accidental damage during installation
Safety wire, lag eye bolts, and strain reliefs
Heat shrink, extension cord
c. Optional items
The optional items suggested below can be added to or substituted for items in the standard VoiceLift Microphone
kit.
• VLR 102 SR Secondary VoiceLift Receiver
• VLC 102 Charging Station
• VLP 102 pendant microphone (additional)
• Wall charger
• Headset microphone
• Lapel microphone
• Lanyard
• Lanyard clip
• IPL T S1 Ethernet Control Interface
d. Installation tools:
• Tape measure
• Screwdriver set and Tweeker
• Hole saw, keyhole saw, or razor knife
• Appropriate drill and bit set for the mounting surface
• Stud nder
• Flashlight
• Safety goggles
• RJ-45 crimpers and connectors (plenum rated, if applicable)
• Zip ties
• Vacuum cleaner
N
If any items in the VoiceLift Microphone boxes are damaged or missing, contact the Extron Technical Hotline
(see rear cover for contact numbers).