Filter
Top Products
13
Model VM08 Owner’s Manual
Mute ON channel (LED is off).
<CAUTION>
If [Fader Fix mode], discussed below, in the [Setup mode] is set to [ON], no signal will be output even
though the fader is moved. The [FADER FIX mode] is set to [OFF]. For details refer to [Setup mode] on
page 27.
Mute of the various input channel/master output:
Mute ON/OFF of channels 1 ~ 4, 5/6, 7/8 and master output can be done using the CH ON/CH
SEL key. Normally, the CH ON/CH SEL keys for channels 1 ~ 4, 5/6, 7/8 and MASTER are all ON
(key LED is lit). Therefore, when the CH ON/CH SEL key of the channel you wish to mute is
pressed, sound from that channel only will be muted (the CH ON/CH SEL key LED of the channel
that was pressed will be extinguished). Mute ON/OFF alternates with each pressing of the CH
ON/CH SEL key.
<Useful information !>
In addition to operating with the CH ON/CH SEL key,
mute ON/OFF of master output is also possible using
the foot switch (Optional Model 8051).
In the foot switch functional setting is set for [Mute
function of master output] in the [Setup mode] of
the VM08, mute can be executed by stepping on the
foot switch. For details on the [Setup mode], please
refer to page 27.
<Useful information !>
In the normal mix mode, if the position of the INPUT fader/MASTER fader before switching off power
is different from when power is switched on (refer to schematic below), the FADER ADJUST and LEVEL
ADJUST key LED’s (red) will flash. This is because the fader setting before switching off power is in
memory, and the VM08 is indicating that fader and level adjustment is possible.
The fader position can be reset to the position prior to switching off power, and the level position can
be deliberately set to the present sound volume setting.
* To return to the setting before switching off power:
Press the flashing FADER ADJUST key (It will enter the fader adjust mode). Subsequently, adjust each
fader position by referring to [Fader adjust mode] explanation.
* To set to the present fader position:
Press the flashing LEVEL ADJUST key and the VM08 will enter the level adjust mode.
Then setup by following [Level adjust mode] on page 27.
If it is not necessary to match the fader positions, the FADER ADJUST key flashing will extinguished
after all faders are moved and the VM08 will return to the normal mix mode.
<Setting at switch on again of power>
<Setting before switch off of power>