Filter
Top Products
17
Model VM08 Owner’s Manual
Lit
Changes to [Post] or [Pre].
If [Pre] is selected, the blinking 3 digits move upward.
Blinking
PRE/POST setup method for EFFECT SEND/AUX SEND
In the procedure here, the effect send and AUX send signals are setup for PRE (pre-fader) or
POST (post fader). In the initial state, EFFECT SEND 1, 2, AUX SEND 1, 2 are all setup for POST
(post fader).
<Useful information!>
PRE (pre-fader) means that the signal is obtained before the INPUT fader and is not affected by the
INPUT fader. POST (post fader) means that the signal is obtained following the INPUT fader and is
affected by the INPUT fader. In other words, in the PRE setting, although the INPUT fader is at MIN,
the EFFECT SEND or AUX SEND levels can be adjusted but in the POST setting, no signal can be sent
if the INPUT fader is at MIN.
1.While pressing the EXIT, press the EFF/AUX key
to light up [E1], [E2], [A1] or [A2] in the status
display section.
The LCD will display the following:
Example: The character display section with [E1]
is lit
[1-E1: Post] is displayed. Now, channel 1 EFFECT
SEND 1 PRE/POST can be setup. This indicates
that the present EFFECT SEND 1 PRE/POST is set
at POST.
2.Press the desired CH ON/CH SEL key and
select the channel you wish to adjust.
3.Adjust the number with the DATA encoder.
[Pre] or [Post] can be selected.
The graphic display will also change at the same
time.
<Useful information!>
When channels 5/6 or 7/8 are selected, the two
channels will be set at the same time. If MAS-
TER is selected, all channels will be at the same
time.