Filter
Top Products
27
Model VM08 Owner’s Manual
Lit
The previously-selected setup menu item will appear.
Blinking
Setup Mode
In Setup mode you can make the following settings to specify how the VM08 will operate.
1. INPUT 5/6 setting (specify INPUT 5/6 as stereo or mono input)
2. INPUT 7/8 setting (specify INPUT 7/8 as stereo or mono input)
3. Fader Fix setting (turn Fader Fix mode on/off)
4. ChFdrRcl setting (turn Recall mode on/off for the channel faders)
5. MsFdrRcl setting (turn Recall mode on/off for the master fader)
6. Foot Sw setting (specify the function of the foot switch)
7. BattVolt check (check the voltage of the internal battery)
Making settings in setup mode
To make settings in Setup mode, use the following procedure to select the menu item that
contains the setting you wish to change. (However, the internal battery check is for display
only, and cannot be modified.)
2. Use the DATA encoder to select the desired
setup menu item.
3. Press the ENTER key.
The currently selected item will blink in the
display.
4.Use the DATA encoder to select the desired
setting.
For details on the available settings, refer to the
following page.
5.Press the ENTER key.
The selection will be finalized, and you will
return to the display of <step 1>.
6.Press the EXIT key.
You will return to Normal Mix mode.
Details of the setup menu
INPUT 5/6 input setting (Display: [Input5/6?])
Here you can specify the input mode for IN-
PUT 5/6.
<Settings>
Stereo (default)
In 5>Mono
If Stereo is selected, the INPUT 5/6 jack will be
used in stereo input mode, and separate sig-
nals will be sent to channels 5 and 6. Use this
setting when inputting a stereo signal. If In
5>Mono is selected, mono input mode will be
used, and the same signal will be input to chan-
nels 5 and 6. Use this setting when inputting a
mono signal. For more about the INPUT 5/6
jack, refer to p.8 "Connecting other equipment."
INPUT 7/8 input setting (Display: [Input7/8?])
Here you can specify the input mode for INPUT
7/8.
<Settings>
Stereo (default)
In 7>Mono
If Stereo is selected, the INPUT 7/8 jack will be
used in stereo input mode, and separate sig-
nals will be sent to channels 7 and 8. Use this
setting when inputting a stereo signal. If In
7>Mono is selected, mono input mode will be
used, and the same signal will be input to chan-
nels 7 and 8. Use this setting when inputting a
mono signal. For more about the INPUT 7/8 jack,
refer to p.8 "Connecting other equipment."
1.Simultaneously press the EFFECT EDIT keys
EFF 1 and EFF 2.
You will enter Setup mode.