Filter
Top Products
14
Model VM08 Owner’s Manual
EQ
[L10] ~ [L1] ~ [C] ~ [R1] ~ [R10] will be displayed.
The digit moves up and down.
Setting Item
Setup of PAN (sound image)
Setup of LO-EQ
Setup of MID-EQ
Setup of HI-EQ
Level setup of EFF SEND 1
Level setup of EFF SEND 2
Level setup of AUX SEND 1
Level setup of AUX SEND 2
PRE/POST setup of EFF SEND 1
PRE/POST setup of EFF SEND 2
PRE/POST setup of AUX SEND 1
PRE/POST setup of AUX SEND 2
Executing Key
Changing the channel Changing the setup content
Blinking Lit
EQ
Channel Parameter Edit Mode
Twelve items, as shown in list below, can be set by the channel parameter edit mode. Regard-
less of the VM08’s current mode, their respective edit modes can be entered by executing the
key operations listed below. To exit from the channel parameter edit mode, press the EXIT key.
When the PAN/EQ key is repeat-
edly pressed, the setup item will
alternately switch. In the initial
state, the channel 1 PAN setup will
be displayed.
When the EFF/AUX key is repeat-
edly pressed, the setup item will
alternately switch. In the initial
state, the channel 1 EFF SEND 1
level setup will be displayed.
If the EFF/AUX key is pressed
while pressing on the EXIT key, the
setup item will alternately switch.
In the initial state, the display will
be PRE/POST setup of channel 1
EFF SEND 1.
Channel 1 is selected in
the initial state and the
channel to be edited is se-
lected by pressing each re-
spective CH ON/CH SEL
key. The CH ON/CH SEL
key LED (green) of the se-
lected channel will blink.
Setup is changed by utilizing
the DATA encoder.
<Useful Information!>
When selecting a desired item, each time the respective key is pressed, it will move to the next item, and
if the key is held down, it will change one item backward in the setup item list.
Setup method for PAN setting
Balance of channels 1 ~ 4, 5/6, 7/8 and STEREO MASTER signals must be setup.
1.Press the PAN/EQ key to light up the [PAN] dot
in the status display section.
The LCD will display the following:
* Character display section:
[1-Pan: C] will be displayed. Now PAN of channel 1
can be setup, and this indicates that the present
PAN setting is for centering the sound image (C).
2.Press the desired CH ON/CH SEL key and
select the channel to be adjusted.
CH ON/CH SEL key of the selected channel will
blink.
3.The number is adjusted with the DATA encoder.
The number can be changed within the range
of [L10] ~ [C] ~ [R10] and the sound image
position will change accordingly. The graphic
display will also change at the same time.
<Useful information!>
When the DATA encoder is activated to set PAN,
its position will be displayed digitally in 21 steps
within the range of [L10] ~ [C] ~ [R10] but the
actual change in sound will be continuous
(smooth). If channels 5/6 and 7/8 had been se-
lected, balance between the two channels can
be setup. If the MASTER had been selected, bal-
ance between L and R can be setup.