Filter
Top Products
28
Model VM08 Owner’s Manual
Battery check (Display: [BattVolt ?])
This lets you check the voltage of the internal
battery. After selecting this menu item, press
the ENTER key. The voltage of the internal bat-
tery will be displayed, allowing you to check it.
When you have checked the voltage, press the
EXIT key to exit Setup mode.
Fader Fix setting (Display: [FaderFix ?])
<Settings>
ON
OFF (default)
If this setting is turned on, the faders will no
longer function in any mode.
This allows you to prevent the fader positions
from being changed by accident or by vibra-
tion.
Channel fader recall setting
(Display: [ChFdrRcl ?])
<Settings>
ON (default)
OFF
If this setting is turned off, only the input fader
settings of each channel will be unaffected when
you recall a scene.
In other words, the six input faders will main-
tain the settings that they had immediately
before the scene was recalled.
Regardless of this on/off setting, the input fad-
ers will continue to function normally in all
modes, as well as when you store a scene.
Master fader recall setting
(Display: [MsFdrRcl ?])
<Settings>
ON (default)
OFF
If this setting is turned off, the setting of the
master fader will be unaffected when you re-
call a scene. In other words, the master fader
will maintain the setting that it had immedi-
ately before the scene was recalled. This is
convenient when you wish to set just the out-
put level yourself, for example during a live
performance.
Regardless of this on/off setting, the master
fader will continue to function normally in all
modes, as well as when you store a scene.
Foot Switch setting (Display: [Foot Sw ?])
Here you can specify the function of the foot
switch.
<Settings>
-> SceneU/D (default)
-> ST Mute
-> EFF1 Mute
-> EFF2 Mute
-> E1&E2 Mute
-> Delay Tap
SceneU/D: Access the Scene Direct Recall
function
Pressing the foot switch once
will enter Scene Direct Recall
mode; subsequent presses of the
foot switch will advance the
scene number forward, and
holding down the foot switch
will return to the previous scene
number.
To exit Direct Recall mode, press
the EXIT key.
ST Mute: Switch muting on/off for the ST
master signal
EFF1 Mute: Switch muting on/off for EFF 1
EFF2 Mute: Switch muting on/off for EFF 2
E1&E2 Mute: Switch muting on/off for EFF 1
/ EFF 2.
Delay Tap: When editing effect parameters,
use the foot switch for tap in
put of Delay Time or BPM.
The life of the internal battery is approximately
two years. When the battery runs down and
the voltage decreases to a certain level, a warn-
ing message of [Batt Empty] will appear in the
display when the VM08 is powered-on. It is not
possible for the user to replace the internal
battery. Please contact a nearby Fostex office
or service station. For details on the [Batt
Empty] message, refer to page 6 "Before Op-
eration."