Filter
Top Products
3
Do not place the product near electrical
appliances such as TVs and
radios.
Take care not to allow any foreign
matter to enter the product.
Before connecting cords, make sure
that the power to this product
and other devices is turned
OFF.
Do not use the product in the following areas.
Areas, such as those near windows, where the product is
exposed to direct sunlight
Extremely hot areas, such as near a heater
Extremely cold areas, such as outside
Extremely humid areas
Areas where a large amount of sand or dust is present
Areas where the product is exposed to excessive vibrations
The product is not completely disconnected from the
power supply even when the power switch is turned
off. If the product will not be used for a long time,
unplug the AC power cord from the AC outlet.
Do not drag the product on the floor.
Take care not to drop the product.
Do not stand on the product or exert
excessive force.
CAUTION
Failure to do so may cause fire in case of lightning.
Failure to do so may over-heat the product, resulting
in fire.
Indicates a potential hazard that could result in injury or
damage to the product or other property if the product
is handled incorrectly
Using the product in such areas may result in product
breakdown.
Use the product only in moderate climates (not in tropical
climates).
Failure to do so may cause breakdown of this product
and other devices.
Doing so may cause the product to generate noise.
If the product generates noise, move the product
sufficiently away from the electrical appliance or
connect it to another AC outlet.
Entry of water, needles or hair pins may result in
breakdown or short-circuit.
The product shall not be exposed to dripping or splashing.
No objects filled with liquids, such as vases, shall be
placed on the product.
Please lift up the product when moving it. Please note
that the product is heavy and must be carried by more
than two persons.
Dropping the product may result in breakdown.
Failure to do so may damage them, resulting in fire,
electric shock or short-circuit.
When disconnecting the AC power cord’s
plug, always hold the plug
and pull it to remove it.
Doing so may result in discoloration or deformation of
the product.
When cleaning the product, put a soft cloth in
lukewarm water, squeeze it well, then wipe the product.
Doing so may cause the product to become deformed or
fall over, resulting in breakdown or injury.
Do not wipe the product with benzene
or thinner.
The product should be located so that its location or position does not interfere with its proper ventilation.
Ensure a minimum distance of 5cm around the product for sufficient ventilation.
Ensure that the ventilation is not impeded by covering the ventilation openings with items,
such as newspaper, table-cloths, curtains, etc.
This product may be equipped with a polarized line plug (one blade wider than the
other). This is a safety feature.
If you are unable to insert the plug into the outlet, contact an electrician to replace
your obsolete outlet.
Do not defeat the safety purpose of the plug.
It is a good practice to have the instrument near the AC outlet and the power cord plug in a position
so that it can readily be disconnected in an emergency because electricity is always charging
while the plug is in the AC outlet even in a power switch off condition.