Filter
Top Products
50
8.2.16 Wheel Mode
This parameter determines whether or not the modulation wheel can be used
to edit parameters like a value dial.
Normal: The wheel functions as a performance wheel and controls the CC
controller that is assigned in the setup menu (Default).
Edit: The wheel is used to edit parameters. The value won’t change until the wheel
reaches the position of the previously set the value. It can be used to edit the
following parameters:
*Setup parameters in the MENU except Zone mode and Sound
*Setup name when stored
*Function SW assign, EFX/REVERB type
*Tempo of the metronome
Note:
When the Wheel Mode is set to “Edit”, the normal function of the wheel is
ineffective,and the wheel parameters will show an asterisk.
8.2.17 Dump Mode
This parameter determines whether or not the dump data is divided into plural
Packets. When a Personal Computer is used for the Dump, if the performance
of the computer or sequencer is insufficient, the MP8II may not dump information
correctly. In such a case, please set the Dump mode to “Divide”.
Normal: Dump data is transmitted as one exclusive data.[default]
Divide: Dump data is transmitted as plural Packets -each max 128bytes. The “Divide”
transmission requires more time than “Normal”.
8.3 System Dump
8.3.1 Dump Current
This function transmits the current and active settings of the MP8II as a System
Exclusive Message via the MIDI OUT.
Press the SYSTEM button. Then press the MENU-DOWN button until “Dump
Current” appears on the display.
Press the VALUE-UP button. The display will ask for confirmation.
To cancel Dump Current at this point, press the VALUE-DOWN button.
Otherwise, press the VALUE-UP button again.
The display will change to read “Completed!!”. Dump Current is complete.