Filter
Top Products
39
6.2.25 Foot Switch
This parameter determines if a Foot Switch connected to the FSW jack is active
(On) or not (Off) for the selected zone. The type of controller assigned to the
footswitch is a common Setup parameter and is used for all zones of a Setup as
a global parameter.
6.2.26 Expression Pedal
This parameter determines if an Expression Pedal connected to the EXP jack is
active (On) or not (Off) for the selected zone. The type of controller assigned
to Expression pedal is a common Setup parameter and is used for all zones of
a Setup as a global parameter.
6.2.27 Modulation
This parameter determines if the Modulation Wheel is active (On) or not (Off)
for the selected zone.
6.2.28 Bender
This parameter determines if the Bender Wheel is active (On) or not (Off) for
the selected zone.
6.2.29 Transmitting Bender Range (Ext only)
This parameter decides if a Bender Range should be transmitted (On) or not
(Off) when a SETUP is recalled. When the Bender is “Off”, this page won’t be
displayed.
6.2.30 Bender Range
Int: This sets the Bender Range in semitone steps. The value changes from 0 to
7.
Ext: This is used to transmit Bender Range information to external sound modules.
If the Tx Bender Range is “On”, the value is transmitted when a SETUP is
recalled. The value changes from 0 to 12.
When the Bender is “Off”, this page won’t be displayed.
6.2.31 Solo
This parameter turns the Solo Mode On/Off.
When Solo is turned “On” only one note will be heard for the selected zone
even if more than one note is being played simultaneously. This can be used to
effectively simulate the performance characteristics of a monophonic synthesizer
or as a special performance tool for playing solo parts. Solo mode can also be
used while playing a polyphonic part from another zone.