Filter
Top Products
49
8.2.11 Receive Channel
This parameter determines whether or not a particular MIDI channel will receive
incoming MIDI data from an external source. This parameter can be used to
filter out data on specific MIDI channels that are not intended for the MP8II.
On: The MP8II responds to MIDI data received on this channel.
Off: The MP8II ignores MIDI data received on this channel.
When the Multi-Timbral Mode is set to Off, this page won’t be displayed.
8.2.12 LCD Contrast
This parameter adjusts the contrast of the LCD display.
As the value changes higher, the contrast gets sharper. The value changes
from 1 to 10.
8.2.13 LED Brightness
This adjusts the brightness of the LEDs. You can choose from High or Low.
The Low setting is designed for dark stages, while the High setting is good for
bright ambience.
8.2.14 Out Mode
Sometimes it is convenient to have two mono outputs instead of a stereo
output.
In this case one mono output can be used for your own monitor system and
the other goes to the mixing console.
Stereo: The signal on the Line-Outs is normal stereo.
2xMono: The signal on the Line-Outs is mono on both jacks
Note:
To avoid unexpected sound issues some stereo effects like AutoPan will be
turned off when 2xMono is selected.
8.2.15 Foot Switch Mode
This parameter sets the mode of FootSW's function.
Normal: The type of controller assigned to the footswitch is a common Setup parameter
"FootSW CC#". (see page41)
Setup+: The footswitch is pushed 1 time, and Setup number will be increased by 1.
Note:
When the value is "Setup+", FootSW CC# page won't be displayed.