Filter
Top Products
7
22.. EERRGGOO PPaanneellss aanndd CCoonnnneeccttiioonnss
22..11 BBaacckk PPaanneell aanndd CCoonnnneeccttiioonnss
In th
e Back panel (Figure 2), ERGO includes:
• On/Off Switch
• Power Input
• FireWire Ports
• SPDIF IN
• Cal Mic Input
• Line Inputs (L & R)
• Calibrate button
• Speaker A and B/Sub Outputs
• Headphone Output
OOnn//OOffff SSwwiittcchh
It s
witches the unit On or Off…
PPoowweerr IInnppuutt
ERG
O’s power input accepts a 12VDC power supply capable of
delivering a minimum of 1 amp. If you intend to keep ERGO
hooked up to the FireWire port on your computer (6-pin), you do
not need to use the external power supply, as ERGO is designed
to use the power coming in via the 6-pin FireWire port.
While ERGO can use a 6-pin FireWire port’s power for itself,
many times this will be a bit “noisy.” If you find this to be true in
your case and you think ERGO is not providing the best sonic
quality that it can, go back to using the external power supply.
Keep in mind, that you will always need to plug ERGO into the
external power supply when using a mini 4-pin FireWire cable
since it does not provide power like its 6-pin counterpart.
FFiirreeWWiirree ppoorrttss
These 2
ports allow input and daisy chaining of FireWire signals.
One of these ports must be used while ERGO is measuring and
calibrating your room.
NNoottee
Us
ually, the FireWire port is only used when ERGO is
running its room analysis. After the analysis is complete, you
can unplug the FireWire interface and still use ERGO in
Standalone mode using the Line or SPDIF Inputs.
SSPPDDIIFF IINN
It rec
eives digital audio data.
CCaall MMiicc IInnppuutt
This j
ack is used to connect the ERGO measurement microphone.
It is only used during the calibration process.
NNoottee
It
is recommended that you use the mic supplied with
ERGO for room calibration. ERGO supplies a 15V phantom
power source to its microphone, and using other mics for
calibration may result in poor room analysis and improper
correction filters.
LLiinnee IInnppuuttss ((LL && RR))
These balanced/unbala
nced audio inputs are used either as
inputs from your existing audio interface or as recording inputs
from a mixer. You may want to use the Analog Inputs for one of
the following reasons:
Figure 2