Filter
Top Products
22
Programming the Controllers
< Introduction to Programming Options
Each of the Ozonic’s controllers can send MIDI CC, RPN/NRPN, GM 1&2, and SysEx messages. They can also be assigned to individual MIDI
channels.
MIDI CC (continuous controller) numbers are part of the standard MIDI specifications and are typically used to control the real-time changing
of parameters in musical equipment. For a complete list of standard MIDI controller numbers from 0 to 131, please see Appendix E.
Any of the real-time controllers on the keyboard can be assigned to a MIDI CC number; the assignable buttons and pedals have slightly
different options from the faders or rotary controllers.
The two charts show the transmit messages that can be programmed for each of the knobs, faders, and assignable buttons.
Please pay extra attention to the differences between programming the faders or knobs and programming the buttons.
< The Fader and Rotary Dials:
MIDI CC Description Data 2 Data 3
0-119 Standard MIDI CC’s Max Min
120-127 Channel Mode Messages Max Min
128 Pitch Bend Sensitivity - -
129 Channel Fine Tune - -
130 Channel Coarse Tune - -
131 Channel Pressure - -
132 RPN coarse RPN LSB RPN MSB
133 RPN fine RPN LSB RPN MSB
134 NRPN coarse NRPN LSB NRPN MSB
135 NRPN fine NRPN LSB NRPN MSB
136 Master Volume GM* - -
137 Master Pan GM* - -
138 Master Coarse Tune GM* - -
139 Master Fine Tune GM* - -
140 Chorus Mod rate GM2* - -
141 Chorus Mod Depth GM2* - -
142 Feedback GM2* - -
143 Send to Reverb GM2* - -
144 Pitch Bend - -
OFF Controller Off*** - -