Filter
Top Products
5 - 63
MELSEC-Q
5 DATA USED FOR POSITIONING CONTROL
Setting Value, setting range
Value set with peripheral device
Setting value buffer memory
address
Servo amplifier setting invalid
(
: Valid, : Invalid)
MR-J3-B
Value set with PLC program
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
0 to 1 0 30100 30300 30500 30700
Regenerative brake
option selection
0
H
1: is used to set up the setting
value.
(
Hexadecimal
)
0
0000
H
30102 30302 30502 30702
0 to 1 0 30103 30303 30503 30703
Forced stop selection
0
H
1: is used to set up the setting
value.
(Hexadecimal)
0000
H
30104 30304 30504 30704
0 to 3
1
H
30108 30308 30508 30708
2: The PA
corresponds with servo parameter No. of the servo amplifier.
3: Set the parameter value and switch power off once (The parameter is transferred to servo amplifier from QD75MH), then switch it
on again to make that parameter setting valid.